高锰TWIP钢中形变孪晶界缺陷的电镜表征研究
谢 盼*,伍翠兰,陈江华*
(1. 海南大学皮米电子显微镜中心,海南海口570228;2. 湖南大学高分辨电镜中心,湖南长沙410082)
摘 要 通常认为孪晶界是完全共格和无缺陷的,但变形过程中产生的孪晶界往往带有很多缺陷。本文通过高分辨透射电镜观察研究了高锰孪生诱发塑性钢(TWIP钢)中形变孪晶界的缺陷特征。结果表明,高锰TWIP钢中形变孪晶界的缺陷包括界面原子台阶、9R结构单元和由于位错和孪晶界相互作用产生的高密度位错。与传统认为9R结构由Σ3 {112} 非共格孪晶界的分解产生不同,形变孪晶界上9R结构单元由晶界直接发射不全位错形成。位错和孪晶界的交互作用造成了孪晶的退化,并在孪晶界附近产生了大量位错,包括高密度的全位错和Frank分位错。基于形变孪晶界缺陷的电镜表征,分析和总结了高锰TWIP钢的强韧化机制。
关键词 TWIP钢;形变孪晶;位错;9R结构
中图分类号:TG142.11;TG142.33;TG115.21+5.3 文献标识码:A doi:10.3969/j.issn.1000-6281.2023.05.005
Electron microscopycharacterization of the defectsofdeformation twin boundariesin high manganese TWIP steels
XIEPan1,2*, WUCui-lan2, CHENJiang-hua1,2*
(1. Pico Electron Microscopy Center, Hainan University, HaikouHainang 570228;
2. Center for High-resolution Electron Microscopy, Hunan University, Changsha Hunan410082, China)
Abstract Twin boundaries (TBs) are usually considered to be coherent and perfect. Here we report that deformation twins in TWIP steels are often defective with steps, 9R structures and massive dislocations formed by the dislocation-TB interactions. These imperfections are finely identified by high-resolution transmission electron microscopy (HRTEM). It is found that some 9R structures can be directly produced by the glide of Shockley partial dislocations (SPDs) emitted from boundaries, which differs from the traditional 9R phase created by the dissociation of Σ3 {112} incoherent TB. Dislocation-TB interactions result in de-twinning at the both sides of the primary deformation twin and produce different types of dislocations near the TBs, including high densities of full dislocations and the Frank partial dislocation. Base on the analysis of various defects at TBs, the mechanism of twinning-induced plasticity and strain hardening is summarized in TWIP steels.
Keywords TWIP steel; deformation twin; dislocation; 9R structure
“全文下载请到同方知网,万方数据库或重庆维普等数据库中下载!”
[1] GRÄSSELO, KRÜGERL, FROMMEYER G, et al. High strength Fe-Mn-(Al, Si) TRIP/TWIP steels development-properties-application[J].Int J Plast, 2000, 16: 1391-1409.
[2] BOUAZIZO, ALLAINS, SCOTTCP, et al.High manganese austenitic twinning induced plasticity steels: A review of the microstructure properties relationships[J].Curr Opin Solid State Mater Sci, 2011,15: 141-168.
[3] BRACKEL, VERBEKENK, KESTENSL, et al.Microstructure and texture evolution during cold rolling and annealing of a high Mn TWIP steel[J].Acta Mater, 2009,57: 1512-1524.
[4] 符晓倩,余倩,张泽. TWIP高熵合金中塑性变形机理的原位电镜研究[J]. 电子显微学报,2019,38(5):452-458.
[5] PIERCEDT, JIMÉNEZJA, BENTLEYJ, et al.The influence of manganese content on the stacking fault and austenite/ε-martensite interfacial energies in Fe-Mn-(Al-Si) steels investigated by experiment and theory[J].Acta Mater, 2014,68: 238-253.
[6] SEOLJB, JUNGJE, JANGYW, et al.Influence of carbon content on the microstructure, martensitic transformation and mechanical properties in austenite/ε-martensite dual-phase Fe-Mn-C steels[J].Acta Mater, 2013,61: 558-578.
[7] JINJE, LEEYK. Effects of Al on microstructure and tensile properties of C-bearing high Mn TWIP steel[J].Acta Mater, 2012,60:1680-1688.
[8] BELADIH, TIMOKHINAIB, ESTRINY, et al.Orientation dependence of twinning and strain hardening behaviour of a high manganese twinning induced plasticity steel with polycrystalline structure[J].Acta Mater, 2011,59: 7787-7799.
[9] GUTIERREZ-URRUTIAI, RAABED. Dislocation and twin substructure evolution during strain hardening of an Fe–22 wt.% Mn–0.6 wt.% C TWIP steel observed by electron channeling contrast imaging[J].Acta Mater, 2011,59: 6449-6462.
[10] HUTCHINSONAB, RIDLEYN. On dislocation accumulation and work hardening in Hadfield steel[J].Scripta Mater, 2006,55: 299-302.
[11] RENARDK, IDRISSIH,SCHRYVERSD, et al. On the stress state dependence of the twinning rate and work hardening in twinning-induced plasticity steels[J].Scripta Mater., 2012,66: 966–971.
[12] WANG Y M, SANSOZ F, LAGRANGE T, et al. Defective twin boundaries in nanotwinned metals [J]. Nature Mater, 2013, 12: 697-702.
[13] SZCZERBA M J, KOPACZ S, SZCZERBA M S. Experimental studieson detwinning of face-centered cubic deformation twins [J]. Acta Mater, 2016, 104: 52-61.
[14] NIS, WANGYB, LIAOXZ, et al.The effect of dislocation density on the interactions between dislocations and twin boundaries in nanocrystalline materials[J].Acta Mater, 2012,60:3181-3189.
[15] CAO Y, WANG Y B, AN X H, et al. Grain boundary formation by remnant dislocations from the de-twinning of thin nano-twins [J]. Scripta Mater, 2015, 100: 98-101.
[16] 隋曼龄,王艳波,崔静萍,等. 透射电镜原位拉伸研究金属材料形变机制[J]. 电子显微学报,2010,19(3):219-229.
[17] DAO M, LU L, SHEN Y F, et al. Strength, strain-rate sensitivity and ductility of copper with nanoscale twins [J]. Acta Mater, 2006, 54: 5421-5432.
[18] 张家宝,李志鹏,杨鲁岩,等. FCC金属中位错与孪晶界交互作用的原子机制[J]. 电子显微学报,2020,39(6):731-743.
[19] LU L, SCHWAIGER R, SHAN Z W, et al. Nano-sized twins induce high rate sensitivity of flow stress in pure copper [J]. Acta Mater, 2005, 53: 2169-2179.
[20] 郝龙虎,黄铭,卢艳,等. 孪晶结构Cu纳米线塑性变形机制的分子动力学模拟研究[J]. 电子显微学报,2019,38(4):321-328.
[21] 谢盼. 含锰TRIP/TWIP钢的强韧化研究[D]. 长沙:湖南大学,2018.
[22] VERCAMMENS, BLANPAINB, DECOOMANBC, et al.Cold rolling behaviour of an austenitic Fe–30Mn–3Al–3Si TWIP-steel: The importance of deformation twinning[J].Acta Mater, 2004,52: 2005-2012.
[23] WANG J, ANDEROGLU O, Hirth J P, et al. Dislocation structures of Σ3 {112} twin boundaries in face centered cubic metals [J]. Appl Phys Lett, 2009, 95: 021908.
[24] ERNST F, FINNIS M W, HOFMANN D, et al. Theoretical prediction and direct observation of the 9R structure in Ag [J]. Phys Rev Lett, 1992, 69: 620-623.
[25] WANG J, LI N, ANDEROGLU O, et al. Detwinning mechanisms for growth twins in face-centered cubic metals [J]. Acta Mater, 2010, 58: 2262-2270.
[26] MEDLIND L, FOILESSM, COHEND. A dislocation-based description of grain boundary dissociation: Application to a 90o <110> tilt boundary in gold[J].Acta Mater, 2001,49:3689-3697.
[27] CÁCERESCH, LUKÁČ P. Strain hardening behaviour and the Taylor factor of pure magnesium[J].Phil Mag, 2008,88:977-989.
[28] MECKINGH, KOCKSUF, HARTIGC.Taylor factors in materials with many deformation modes[J].Scripta Mater, 1996,35: 465-471.
[29] LI X Y, WEI Y J, LU L, et al. Dislocation nucleation governed softening and maximum strength in nano-twinned metals [J]. Nature, 2010, 464: 877–880.
[30] LIU S, QIAN L H, MENG J Y, et al. On the more persistently-enhanced strain hardening in carbon-increased Fe-Mn-C twinning-induced plasticity steel [J]. Materials Science and Engineering A, 2015, 639: 425-430.
[31] IDRISSI H, RENARD K, SCHRYVERS D,et al. On the relationship between the twin internal structure and the work-hardening rate of TWIP steels [J]. Scripta Mater., 2010, 63: 961-964.